9V Battery Holder and Connector
October 11, 2023L293D Motor Driver Shield for Arduino
October 11, 2023830 points Breadboard
Are you a beginner in building circuit design?
A breadboard is ideal for a beginner to learn in building circuitry. The breadboard does not require soldering to make connections. Sometimes, it is called a solderless breadboard. You can just experiment with your circuit design by plugging in the components without any soldering. Thus, this breadboard and the components are reusable, you can modify your circuit easily without any hesitation. With this feature, it is suitable for beginners like students to build the prototype on the breadboard in order to test the circuit design.
RM8.00
1 in stock
Specifications:
- Full-size breadboard
- Total 830 holes
- Standard 2.54mm (0.1″) spacing between two holes
- Dimension: 16.5×5.5cm
- Common Rating: 1A @ 5V or 5 Watt
Related products
-
L293D Motor Driver Shield for Arduino
RM25.00DescriptionThis L293D shield for Arduino, particularly Arduino UNO, CT-UNO, is perfect for driving 4 brush motors or 2 stepper motors and it can even supports RC servo motor. It also equiped with serial to parallel expansion IC 74HC595.
-
5VDC 10A Single Channel Relay Module compatible with arduino
RM5.00DescriptionNote: From February 2020 onwards, the module comes with a logic low circuit.
The Relay breakout board is a convenient board to be used with 5V microcontrollers such as SK40C, SK28A, Arduino, SKds40A, SK18B. You can easily use 5V signal to control the relay. Three inputs:
- VCC = 5V is needed
- GND = Common Ground, 0V
- IN = Control signal need to be
5V0V to activate the Relay (Active Low)
The relay terminals (COM, NO, and NC) are brought out using a 3-way screw terminal. On-board relay is rated at 10A. It can be used in many applications: controlling high voltage, high current loads such as motor, solenoid valves, lamps, and AC load. It also comes with 2 LEDs to indicate the status power (VCC) and the status of the relay.
Note: This is an
active-highactive-low device, which means logichigh (5V)low (0V) at pin IN will trigger the relay.
Reviews
There are no reviews yet.