LCD Module 16×2 (Green Backlight) for Arduino
October 10, 2023
LM35DZ Temperature Sensor for Arduino
October 11, 2023
2.4 inch TFT LCD Display Module for Arduino
The shield is fully assembled, tested, and ready to go. No wiring, no soldering! Simply plug it in and load up the library – you’ll have it running in under 10 minutes!
RM40.00
Out of stock
- 2.4″ diagonal LCD TFT display.
- Bright, 4 white-LED backlights, by default but you can connect the transistor to a digital pin for backlight control.
- Colorful, 18-bit 262,000 different shades.
- 4-wire resistive touchscreen.
- 8-bit digital interface, plus 4 control lines.
- Uses digital pins 5-13 and analog 0-3.
- Useable digital pins 2, 3, and analog 4 and 5. Pin 12 is available if not using the micro
- 5V compatible, use with 3.3V or 5V logic.
- Size:72 x 52 x 12 mm
- Weight:33 g
- Package weight:43 g
Related products
-
4 Channel relay Module compatible with arduino
RM20.00Relays are always good to have especially for electronics projects. Relay itself offers two main benefits:
- Isolation of low voltage system against high voltage system, example 5VDC and 240VAC
- Allow electronics with low voltage to control high power load, example from Arduino to AC light bulb.
-
DHT11 Humidity & Temperature Sensor compatible with arduino
RM12.00DescriptionDHT11 is the most common sensor that is usually used by students and makers out there. The main function of this sensor is to measure the temperature and humidity of the surroundings. The sensor is also factory calibrated and hence easy to interface with any microcontrollers like Arduino. The sensor can measure temperature from 0°C to 50°C and humidity from 20% to 90% with an accuracy of ±1°C and ±1%. So if you are looking to measure in this range then this sensor might be the right choice for you!
The DHT11 sensor can either be purchased as a sensor or as a module. Either way, the performance of the sensor is the same. The sensor will come as a 4-pin package out of which only three pins will be used whereas the module will come with three pins as shown below. The only difference between the sensor and module is that the module will have a filtering capacitor and pull-up resistor inbuilt so that you can just simply connect wires and start your project!
-
830 points Breadboard
RM8.00DescriptionAre you a beginner in building circuit design?
A breadboard is ideal for a beginner to learn in building circuitry. The breadboard does not require soldering to make connections. Sometimes, it is called a solderless breadboard. You can just experiment with your circuit design by plugging in the components without any soldering. Thus, this breadboard and the components are reusable, you can modify your circuit easily without any hesitation. With this feature, it is suitable for beginners like students to build the prototype on the breadboard in order to test the circuit design.
Reviews
There are no reviews yet.