3 Way Terminal Block
January 5, 2024
Round Motor Coupling
January 8, 2024
2WD Car Robot Chassis
RM25.50
2WD Car Robot Chassis
- 2 wheels + motors mobile robot chasis
- Comes with all accessories to make a mobile robot
- Include 4xAA batteries holder
- Chassis size: ~215mm x ~150mm
- Wheel Diameter: 67mm
- Castor Height: 34mm
Related products
-
HC-05 Bluetooth Module compatible with Arduino
RM30.00This is the popular Bluetooth module, HC05 which can be configured as master or slave.
- Master Bluetooth will be able to search for other Bluetooth devices and initiate a connection.
- Slave Bluetooth cannot search for other Bluetooth devices and can wait for the master to initiate a connection and accept the connection.
-
220 ohm 1/2W Resistor
RM0.10a resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, divide voltages, bias active elements, and terminate transmission lines, among other uses.
-
5VDC 10A Single Channel Relay Module compatible with arduino
RM5.00DescriptionNote: From February 2020 onwards, the module comes with a logic low circuit.
The Relay breakout board is a convenient board to be used with 5V microcontrollers such as SK40C, SK28A, Arduino, SKds40A, SK18B. You can easily use 5V signal to control the relay. Three inputs:
- VCC = 5V is needed
- GND = Common Ground, 0V
- IN = Control signal need to be
5V0V to activate the Relay (Active Low)
The relay terminals (COM, NO, and NC) are brought out using a 3-way screw terminal. On-board relay is rated at 10A. It can be used in many applications: controlling high voltage, high current loads such as motor, solenoid valves, lamps, and AC load. It also comes with 2 LEDs to indicate the status power (VCC) and the status of the relay.
Note: This is an
active-highactive-low device, which means logichigh (5V)low (0V) at pin IN will trigger the relay.
Reviews
There are no reviews yet.