100PCS 3mm 5mm 940nm LEDs Infrared Emitter and IR Receiver Diode Diodes 301A for Arduino
Model Number : LEDs Infrared Emitter and IR Receiver
Related products
-
Sg90 Tower Pro Mini Servo Motor Compatible with Arduino
RM9.00DescriptionNote: If you are using a microcontroller based on Raspberry Pi, micro:bit, REKA:BIT (ZOOM:BIT), and ESP WiFi series, we recommend using TS90A micro servo which supports 3.3 DC Voltage.
This is a low-cost plastic gear RC servo with 1.80kg.cm holding torque (at 4.8V). It is a perfect solution for student robotic projects who build arms or linkages. The advantage of the RC servo over the DC brush motor is the ability to control its rotation angle.If you are building a system or project that uses many RC servo motors, please consider getting the 8 Channels Servo Controller. They will make your life easier. -
DHT11 Humidity & Temperature Sensor compatible with arduino
RM12.00DescriptionDHT11 is the most common sensor that is usually used by students and makers out there. The main function of this sensor is to measure the temperature and humidity of the surroundings. The sensor is also factory calibrated and hence easy to interface with any microcontrollers like Arduino. The sensor can measure temperature from 0°C to 50°C and humidity from 20% to 90% with an accuracy of ±1°C and ±1%. So if you are looking to measure in this range then this sensor might be the right choice for you!
The DHT11 sensor can either be purchased as a sensor or as a module. Either way, the performance of the sensor is the same. The sensor will come as a 4-pin package out of which only three pins will be used whereas the module will come with three pins as shown below. The only difference between the sensor and module is that the module will have a filtering capacitor and pull-up resistor inbuilt so that you can just simply connect wires and start your project!
-
5VDC 10A Single Channel Relay Module compatible with arduino
RM5.00DescriptionNote: From February 2020 onwards, the module comes with a logic low circuit.
The Relay breakout board is a convenient board to be used with 5V microcontrollers such as SK40C, SK28A, Arduino, SKds40A, SK18B. You can easily use 5V signal to control the relay. Three inputs:
- VCC = 5V is needed
- GND = Common Ground, 0V
- IN = Control signal need to be
5V0V to activate the Relay (Active Low)
The relay terminals (COM, NO, and NC) are brought out using a 3-way screw terminal. On-board relay is rated at 10A. It can be used in many applications: controlling high voltage, high current loads such as motor, solenoid valves, lamps, and AC load. It also comes with 2 LEDs to indicate the status power (VCC) and the status of the relay.
Note: This is an
active-highactive-low device, which means logichigh (5V)low (0V) at pin IN will trigger the relay.
Reviews
There are no reviews yet.