Water Level / Depth Sensor for Arduino
November 27, 2023
KY-026 Flame Detection Sensor for Arduino
November 27, 2023
TCS3200 Color Sensor Recognition for Arduino
RM19.50
- TCS3200 chip is designed to detect the colour of light incident on it
- It has an array of photodiode (a matrix of 8×8, so a total 64 s
- These photodiodes are covered with four types of filters
- Sixteen sensors have RED filter over them thus can measure only
- Likewise other sixteen have GREEN filter and sixteen have BLUE filter
Related products
-
9V Battery Holder and Connector
RM3.00DescriptionThe Battery Holder is suitable for 9 Volt Batteries. The pro of having this battery holder is that it allows you to switch off power for Arduino without having to remove the DC barrel plug each time. This Battery Holder has an easy-remove sliding cover. The removable battery cover is at the opposite side of the ON/OFF switch.
-
DHT11 Humidity & Temperature Sensor compatible with arduino
RM12.00DescriptionDHT11 is the most common sensor that is usually used by students and makers out there. The main function of this sensor is to measure the temperature and humidity of the surroundings. The sensor is also factory calibrated and hence easy to interface with any microcontrollers like Arduino. The sensor can measure temperature from 0°C to 50°C and humidity from 20% to 90% with an accuracy of ±1°C and ±1%. So if you are looking to measure in this range then this sensor might be the right choice for you!
The DHT11 sensor can either be purchased as a sensor or as a module. Either way, the performance of the sensor is the same. The sensor will come as a 4-pin package out of which only three pins will be used whereas the module will come with three pins as shown below. The only difference between the sensor and module is that the module will have a filtering capacitor and pull-up resistor inbuilt so that you can just simply connect wires and start your project!
-
220 ohm 1/2W Resistor
RM0.10a resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, divide voltages, bias active elements, and terminate transmission lines, among other uses.
Reviews
There are no reviews yet.