Photosensitive Sensor Module (LDR sensor module)
October 10, 20232.4 inch TFT LCD Display Module for Arduino
October 11, 2023LCD Module 16×2 (Green Backlight) for Arduino
This is a basic text-based 16 characters by 2 lines LCD with white character on blue backlight. It utilizes the extremely common HD44780 parallel interface chipset.
RM9.90
Out of stock
Specifications:
- 16 x 2 characters LCD
- Blue backlight white character
- Built in controller (HD44780 or equivalent)
Dimension:
- 80.3 x 36.1 x 11.0 mm
Related products
-
Photosensitive Sensor Module (LDR sensor module)
RM5.00The Light sensor module comes with the basic components for light detection. Supplying power and it is good to be used. Use it to detect the light brightness in your environment and decide to switch OFF or ON light. Or maybe adjust the brightness of the LED for your house? It comes with digital and analog output. You can adjust the threshold (sensitivity) of the digital output by tuning the onboard variable resistor (potentiometer). Simple usage as it is a digital output, so you will know if the light is presented and decide what to do with it. Check the schematic for more details.
-
5VDC 10A Single Channel Relay Module compatible with arduino
RM5.00DescriptionNote: From February 2020 onwards, the module comes with a logic low circuit.
The Relay breakout board is a convenient board to be used with 5V microcontrollers such as SK40C, SK28A, Arduino, SKds40A, SK18B. You can easily use 5V signal to control the relay. Three inputs:
- VCC = 5V is needed
- GND = Common Ground, 0V
- IN = Control signal need to be
5V0V to activate the Relay (Active Low)
The relay terminals (COM, NO, and NC) are brought out using a 3-way screw terminal. On-board relay is rated at 10A. It can be used in many applications: controlling high voltage, high current loads such as motor, solenoid valves, lamps, and AC load. It also comes with 2 LEDs to indicate the status power (VCC) and the status of the relay.
Note: This is an
active-highactive-low device, which means logichigh (5V)low (0V) at pin IN will trigger the relay. -
830 points Breadboard
RM8.00DescriptionAre you a beginner in building circuit design?
A breadboard is ideal for a beginner to learn in building circuitry. The breadboard does not require soldering to make connections. Sometimes, it is called a solderless breadboard. You can just experiment with your circuit design by plugging in the components without any soldering. Thus, this breadboard and the components are reusable, you can modify your circuit easily without any hesitation. With this feature, it is suitable for beginners like students to build the prototype on the breadboard in order to test the circuit design.
Reviews
There are no reviews yet.